Pro/Forums - View Single Post

pkmyt1 · 08-10-2007, 02:13 PM

My SNAP 2200 died recently and after much research I determined that one of the drives was bad. (2x250Gb Maxtor) Unfortunately I did not have the drives mirrored . I would like to replace the drives with Western Digital. I have attempted to boot the server with the good drive with or with out the new drive present. The server appears to boot fine but shows up as unconfigured in the Assist utility. When I attempt to configure it I get various messages stating that the IP change was not successful. This is running SNAP os V4.0. I am somewhat of an amature with the SNAP servers and would really appreciate any clues as to what is wrong.

Thank you.

08-10-2007, 02:13 PM	#1
pkmyt1 Cooling Neophyte Join Date: Aug 2007 Location: North Carolina Posts: 6	SNAP 2200 Not Accepting IP My SNAP 2200 died recently and after much research I determined that one of the drives was bad. (2x250Gb Maxtor) Unfortunately I did not have the drives mirrored . I would like to replace the drives with Western Digital. I have attempted to boot the server with the good drive with or with out the new drive present. The server appears to boot fine but shows up as unconfigured in the Assist utility. When I attempt to configure it I get various messages stating that the IP change was not successful. This is running SNAP os V4.0. I am somewhat of an amature with the SNAP servers and would really appreciate any clues as to what is wrong. Thank you.