Re: Help with making new water block
How deep can a hole saw cut?
I would be using plexi, if the plexi sheets are held tighly there is no chance of leaks through them right?
Is there any way I could 'hollow' up the copper plate using just a drill machine?
I have always had bad luck with silicon and I am never going to use it again for whatever purpose it be.
The barbs would be held through the plexi sheets by a nut. Now just need to cut plexi properly as I cannot get a straight cut.
__________________
NOTE: Suggestions are based on my perceptive. I could be erroneous. Therefore, no one has the right to criticize an individual other than rephrasing and or expressing his own annotations on the subject matter itself. 
|