Pro/Forums - View Single Post

ibmkg · 10-08-2007, 12:24 PM

I guess you should have patented your design.

I wonder how they fused the two metals together. And what if I use Cu fins and solder them (from front i.e. where the water is going to flow, not from the back). And eventually lap its back i.e. processor contact area.

And perhaps use silver bearing solder. And how about thermal epoxy for bonding?

10-08-2007, 12:24 PM	#15
ibmkg Cooling Savant Join Date: Jan 2005 Location: USA Posts: 129	Re: Help with making new water block I guess you should have patented your design. I wonder how they fused the two metals together. And what if I use Cu fins and solder them (from front i.e. where the water is going to flow, not from the back). And eventually lap its back i.e. processor contact area. And perhaps use silver bearing solder. And how about thermal epoxy for bonding? __________________ NOTE: Suggestions are based on my perceptive. I could be erroneous. Therefore, no one has the right to criticize an individual other than rephrasing and or expressing his own annotations on the subject matter itself.