Pro/Forums - View Single Post

derelict · 04-10-2008, 01:39 PM

I'm in the same boat as dawg, I'm a bit confused on the fill port. If I understand loops correctly, that fill line in the drawing could be replaced by (or basically is) a res right? And a lot of res' have a cap for filling/bleeding, is that right?

The way I envision the loop working is Pump (out) -> blocks -> rad -> pump (in), is that not correct, or not the best way?

04-10-2008, 01:39 PM	#10
derelict Cooling Neophyte Join Date: Mar 2008 Location: Denver, CO Posts: 39	Re: 1st Time WCer I'm in the same boat as dawg, I'm a bit confused on the fill port. If I understand loops correctly, that fill line in the drawing could be replaced by (or basically is) a res right? And a lot of res' have a cap for filling/bleeding, is that right? The way I envision the loop working is Pump (out) -> blocks -> rad -> pump (in), is that not correct, or not the best way?