Quote:
|
Originally Posted by bigben2k
What if you used a thermal adhesive, and mount a small copper fin between the inlet and outlet? It could also act to put some clamping pressure on the core.
Just an idea.
|
My orginal plan was jets with a center inlet but not enough room for an outlet. I didn't have time to make a 2 peice top to accomadate it.
Peice in the middle might help but highly doubt it would help enough to make much difference. With the onboard thermal probe I doubt I could measure it.
This system is pulled apart and already running Linux with the stock air cooler. I learned all I needed to know.
And no ben333 not selling it. This block will only work on a socket 754 platform anyway. Not satisfied with the quality of the work on it either. Wouldn't take much to break the o-ring free and soak a system.