Pro/Forums - View Single Post

m_kelder · 02-10-2002, 12:36 AM

I was planning on making a case just for the motherboard and vid card, everything else would be outside of the vacuum. Purhaps making little enclosures around the waterblocks would be better. Seems to me that it would be much easier and less problematic that way. I could put two way foam tape on the surface of the pcb and the enclosure unit around the block and tubing, creating a seal and then the vacuum. That way I could see if something was going wrong, plus it would look good...

02-10-2002, 12:36 AM	#3
m_kelder Cooling Neophyte Join Date: Oct 2001 Posts: 4	I was planning on making a case just for the motherboard and vid card, everything else would be outside of the vacuum. Purhaps making little enclosures around the waterblocks would be better. Seems to me that it would be much easier and less problematic that way. I could put two way foam tape on the surface of the pcb and the enclosure unit around the block and tubing, creating a seal and then the vacuum. That way I could see if something was going wrong, plus it would look good...