Pro/Forums - View Single Post

CraigD · 05-17-2008, 02:01 AM

I have two model 1100 servers with 80 GB drives and version 3.4.X software. Both are now working fine (one was dead, but I was able to clone the drive from the other to a new 80 GB drive and am good to go).

I recently tried an experiment in which I sector copied the first part of one of the 80 GB drives onto a Seagate 250 GB drive. The 1100 booted up fine, but reported 80 GB. I then used the online disk utilities to reformat and after it was done, it reported as a 130 GB drive.

I thought that the 1100 with this version firmware was able to handle 250 GB drivers. The current 130 GB is better than 80 GB, but would like to get the full drive. Is anyone aware of a way in which I can get the full 250 GB?

Thanks in adavce for any help.

Craig

05-17-2008, 02:01 AM	#1
CraigD Cooling Neophyte Join Date: May 2008 Location: VA Posts: 5	Newbie with drive upgrade questions I have two model 1100 servers with 80 GB drives and version 3.4.X software. Both are now working fine (one was dead, but I was able to clone the drive from the other to a new 80 GB drive and am good to go). I recently tried an experiment in which I sector copied the first part of one of the 80 GB drives onto a Seagate 250 GB drive. The 1100 booted up fine, but reported 80 GB. I then used the online disk utilities to reformat and after it was done, it reported as a 130 GB drive. I thought that the 1100 with this version firmware was able to handle 250 GB drivers. The current 130 GB is better than 80 GB, but would like to get the full drive. Is anyone aware of a way in which I can get the full 250 GB? Thanks in adavce for any help. Craig