Pro/Forums - View Single Post

Jim · 02-10-2002, 08:04 PM

Ironic, I just lapped my Maze2 this afternoon. It did have small mill marks.

I am glad I did lap it, it was already shiny but, it had a slight low spot where the CPU will contact the water block. Didn't even notice it with the straight edge upon inspection.

Started with 320, 400, 600, 800, 1000, 1500 and 2000. Took me longer than it should have since at the 1500 level some junk got on the paper and scratched the block and I had to go back to 400 and start over.

I was wondering if AS2 or AS3 would be less effective is the surface is too smooth, interesting you guys bring that up.

Jim

02-10-2002, 08:04 PM	#16
Jim Cooling Savant Join Date: Feb 2002 Location: Illinois Posts: 389	Ironic, I just lapped my Maze2 this afternoon. It did have small mill marks. I am glad I did lap it, it was already shiny but, it had a slight low spot where the CPU will contact the water block. Didn't even notice it with the straight edge upon inspection. Started with 320, 400, 600, 800, 1000, 1500 and 2000. Took me longer than it should have since at the 1500 level some junk got on the paper and scratched the block and I had to go back to 400 and start over. I was wondering if AS2 or AS3 would be less effective is the surface is too smooth, interesting you guys bring that up. Jim