Re: Peltier cooling
I have a 2mm Cu sheet that I can use for base plate.
What worries me is the contact area between peltier and WB. It is not much, I do not have a pic of my WB but see this pic for an idea:
http://www.frostytech.com/articleima...lpentD_bot.jpg
The WB I have has a round base contact area of about 28mm diameter.
The peltier is 40mm x 40mm.
__________________
NOTE: Suggestions are based on my perceptive. I could be erroneous. Therefore, no one has the right to criticize an individual other than rephrasing and or expressing his own annotations on the subject matter itself. 
Last edited by ibmkg; 09-09-2008 at 12:26 PM.
|