OK so what u r saing is to rub a thin layer on the bottom of the block then sand w/ 2000 grit paper? Sounds like a good idea? After each level of sanding, with what do you wipe the block off with?
If I do stay with 600 grit as max would you still recommend using as2 or as3 as the lube? In that case after you wipe the block off you would not need to do anything else to the block right? Just clean off core and apply the block?
Perhaps one of you or all of you could post a quick tutorial of lapping from the start to the finish. Pictures would be very helpful.
|