[patlin]

Daer blue68f100,

thx for your fast and professional support
i hope it will work

"install drive 1 and start the unit"
* you mean IDE1 right? --> do I have to set the hd to master or slave? or let it to cable selected?


i just plugged it in --- 8pm here now
so hope it will run again at 8:15pm hehe
just to correct myself, i fomated the hd under windows!!!!

my follow steps would be:
----------------------------------------------------------

1. install first hd on IDE1, cable selected
2. Power ON, SNAP 4000
3. wait 10-15min
4. connect via setup assist
5. set ip via webgui

=====================================
# Urgh does not work updated8:32pm
both setup assists (Version 3.x and 4.x) are not able to find the device




if not -- i going to try this:

1. install first hd on IDE1, ?cable selected?
2. connect hd with external ps from pc
3. Power ON, SNAP 4000
4. wait 10-15min
5. connect via setup assist
6. set ip via webgui

thx a lot
patlin

p.s. i will give you an update