Pro/Forums - View Single Post - Plz HELP --- installed 4x new HD on my SNAP4000 and now its DEAD

patlin · 11-14-2008, 12:11 PM

hi all,

short update:
_________________________________________________

if not -- i going to try this:

1. install first hd on IDE1, ?cable selected?
2. connect hd with external ps from pc
3. Power ON, SNAP 4000
4. wait 10-15min
5. connect via setup assist
6. set ip via webgui

does not work either!
i tired to reset the snapsaver but i'm not able to do it, because the DISK-LED never gets lighted !!!
--> (wait until both the System and Disk lights start flashing in sync)

Could any screenshots help to analyse the status of the device??
LED status is: SYSTEM LED: Steady Light --- DISK LED: off ; do not care about 10min-30min running.

thx for everything, investing your time on my issue

11-14-2008, 12:11 PM	#4
patlin Cooling Neophyte Join Date: Nov 2008 Location: germany Posts: 8	Re: Plz HELP --- installed 4x new HD on my SNAP4000 and now its DEAD hi all, short update: _________________________________________________ if not -- i going to try this: 1. install first hd on IDE1, ?cable selected? 2. connect hd with external ps from pc 3. Power ON, SNAP 4000 4. wait 10-15min 5. connect via setup assist 6. set ip via webgui does not work either! i tired to reset the snapsaver but i'm not able to do it, because the DISK-LED never gets lighted !!! --> (wait until both the System and Disk lights start flashing in sync) Could any screenshots help to analyse the status of the device?? LED status is: SYSTEM LED: Steady Light --- DISK LED: off ; do not care about 10min-30min running. thx for everything, investing your time on my issue Last edited by patlin; 11-14-2008 at 01:08 PM.