[rpmurray]

Repair All Errors found 21 partially allocated inodes (they were all grouped in the same area from 28329230 to 28329252) in Phase 1 - Check Blocks and Sizes, and 5 files with various inode related errors in Phase 2 - Check Pathnames (if the paths it displayed are correct, nothing I don't already have backed up). Phase 4 - Check Reference Counts had only 2 errors. It fixed all the errors and passed through the rest without problems and is now in the middle of re-syncing the raid.

At this point I'm able to access the snap and am copying off the one folder that I didn't have a backup of.

As soon as my new raid gets through with it's disk scans (just to make sure there are no problems on the new disks, only two and a half days to go) I'll copy everything over and then decommission the 4100.

I really wish the folks at GRC would bring out a new version of Spinrite that works natively with SATA drives. I couldn't use it with the new 2TB drives in the new raid because it was going to take over 180 hours each for the four drives and I didn't want to wait a month for it to finish. So I'm using the disk scan built into my drive formatting software, which will only take two and a half days. It's better than nothing.