Pro/Forums - View Single Post

blue68f100 · 03-24-2010, 06:43 PM

If it's hanging in the 5% area, this is where the inodes and super blocks are. This is where the HD's will fail. Some have left the units up and it took over 10 day if I recall to finish the check. SnapOS is an modified bsd file system, nothing reads these except another snap or recovery service.

Also read the FAQ's on 4100's MB patch/fix. If your was an original 160 (4x40gig) from snap it was/should have the mod or a rev3+ to correct the problem. If it was upgraded at a later date the low capacity units were not patched because the problem only showed up on the higher cap models.

03-24-2010, 06:43 PM	#7
blue68f100 Thermophile Join Date: Jul 2005 Location: Plano, TX Posts: 3,135	Re: Disk Check stuck at 5% If it's hanging in the 5% area, this is where the inodes and super blocks are. This is where the HD's will fail. Some have left the units up and it took over 10 day if I recall to finish the check. SnapOS is an modified bsd file system, nothing reads these except another snap or recovery service. Also read the FAQ's on 4100's MB patch/fix. If your was an original 160 (4x40gig) from snap it was/should have the mod or a rev3+ to correct the problem. If it was upgraded at a later date the low capacity units were not patched because the problem only showed up on the higher cap models. __________________ 1 Snap 4500 - 1.0T (4 x 250gig WD2500SB RE), Raid5, 1 Snap 4500 - 1.6T (4 x 400gig Seagates), Raid5, 1 Snap 4200 - 4.0T (4 x 2gig Seagates), Raid5, Using SATA converts from Andy Link to SnapOS FAQ's http://forums.procooling.com/vbb/showthread.php?t=13820