Pro/Forums - View Single Post

Lost · 02-13-2002, 04:58 PM

Well I working on my YY case. I just put my sixth layer of color coat on it. I should be finshed painting by the end of the week; then I'll start transfering my current watercooling set-up.
Right now Im using DD Mazep4, GPU block through a DD heatercore. There is one adj enermax 120 pulling air through heatcore. It works alright during noraml operations. But when I go a binge of CS or benchmarking it gets 7-10 degrees above room temp. On my new set-up Ill have the Highflow Panaflo shrouded(about 1.5" away) pushing air from the rear of the case through heatercore.

Now my question is: should I add my other panaflo to the mix pulling air through my rad??; thus having a push/pull combo.

Now I dont have any pelts and Im using a P4 and a Ati8500 which are both cool runners to begin w/. So what is my best option? 1 fan or 2? BTW I do have a bay bus so Ill only be cranking them when needed.

thanks

02-13-2002, 04:58 PM	#1
Lost Cooling Neophyte Join Date: Jan 2002 Location: NJ Posts: 21	2 or 1 Panaflo Highflow on heatercore? Well I working on my YY case. I just put my sixth layer of color coat on it. I should be finshed painting by the end of the week; then I'll start transfering my current watercooling set-up. Right now Im using DD Mazep4, GPU block through a DD heatercore. There is one adj enermax 120 pulling air through heatcore. It works alright during noraml operations. But when I go a binge of CS or benchmarking it gets 7-10 degrees above room temp. On my new set-up Ill have the Highflow Panaflo shrouded(about 1.5" away) pushing air from the rear of the case through heatercore. Now my question is: should I add my other panaflo to the mix pulling air through my rad??; thus having a push/pull combo. Now I dont have any pelts and Im using a P4 and a Ati8500 which are both cool runners to begin w/. So what is my best option? 1 fan or 2? BTW I do have a bay bus so Ill only be cranking them when needed. thanks