Hi microsvc,
When you say unaccessible are you talking about the webgui share folders? Have you tried to ftp in to the unit?
There are limitations to the SnapOS as far as files and folder maxs and file size.
Have you tried to reset the unit? Also, I would check the drive with HDD Regenerator. I find this software to be the best. If you think it might have a problem. Also, check to make sure the fan is running and not going bad. I believe the fan kicks on at 110F from my memory.
bitor
The light coming on a lot could be from disk swaping more so than normal because the lack of RAM memory(32MB) and large hard drive. When you install larger HD on these units I highly recommend getting the most memory possible on the hard drive's PCB board.
Quote:
Originally Posted by microsvc
I recently installed a larger drive in my 1000 (320gB) and it worked well. Over the past few days, it became unaccessible. Here's a few lines from my logs:
E File System Check : FSCK fatal error = 4 Disk 10000 7/24/2010 1:56:04 PM
E File System Check : Cannot Read: Blk 82304 Disk 10000 7/24/2010 1:56:04 PM
I File System Check : ** Phase 1 - Check blocks and sizes Disk 10000 7/24/2010 1:55:23 PM
I File System Check : partition is clean. Disk 10000 7/24/2010 1:55:22 PM
I File System Check : Executing fsck /dev/ride0a /force Disk 10000 7/24/2010 1:55:22 PM
Does fatal error 4 mean the drive has failed? The disk activity LED is on a lot.
Thanks. ~Bob
|