Pro/Forums - View Single Post - My 4500 doesn't respond to the power control switch

LarryInCa · 08-13-2010, 03:48 PM

Same server, different problem

I can't get my 4500 server to wake back up after powering it down. The last action I took was to go into the GUI and shut it down, as I needed to move the box.

After plugging it back in, nothing happened while pressing the power button

Tried swapping power cords, but no change. The green led on the PS blinks when I plug it back in, and the MB has a green LED in the center that lights. Remove the cord and both of the LED's go out.

I checked all of the internal plugs to make sure they were seated, and they were. I unplugged and replugged the ribbon cable that goes to the power switch / led PCB. I pulled the CMOS battery, and replaced it. I pulled the PS and reseated it.

No change.

Could use some suggestions on what to try next.

08-13-2010, 03:48 PM	#1
LarryInCa Cooling Neophyte Join Date: Jul 2010 Location: California Posts: 14	My 4500 doesn't respond to the power control switch Same server, different problem I can't get my 4500 server to wake back up after powering it down. The last action I took was to go into the GUI and shut it down, as I needed to move the box. After plugging it back in, nothing happened while pressing the power button Tried swapping power cords, but no change. The green led on the PS blinks when I plug it back in, and the MB has a green LED in the center that lights. Remove the cord and both of the LED's go out. I checked all of the internal plugs to make sure they were seated, and they were. I unplugged and replugged the ribbon cable that goes to the power switch / led PCB. I pulled the CMOS battery, and replaced it. I pulled the PS and reseated it. No change. Could use some suggestions on what to try next.