View Single Post
Unread 02-15-2002, 07:27 PM   #3
Chuki
Cooling Neophyte
 
Join Date: Aug 2001
Location: Walla Walla, Washington
Posts: 41
Default

Pretty nice down here in Wally World too. I just stuck my bezel on the case and my temps increased to about 38C idle, man I need to get those stock fans out, and some panaflos in and I need to mod my front Bezel...

I also my setup goes Rad>pump>block>rad I did this for a reason of not having alot of bends in my hose.

I need to replace 1 hose as I cut it kinda short, you can probably tell which one from the picture

Also I just have distilled water in it, but I wanted some opinions of on this water wetter stuff? or Purple Ice. I was just gonna use some more distilled water and some anti-freeze.

But if anyone has some suggestions on decreasing my temps a little more I would appreciate it. These temps are alot better then before, I was expecting kinda lower, but then again I'm killing alotta noise in my system, so I'm sure running fans at lower rpms might have something to do with it.

I got a crystalfontz lcd module on the way, and I'm gonna write a program for it, that as temps increase fans will spin up.

Also is it possible to get a pelt that may only decrease temps by 10-12C and will plug into your powersupply? Something that I wouldn't have to worry about condensation
__________________
EPoX 8k3a+ | XP1900+ 10x180 | ATI Radeon 9700 Pro | 512 XMS PC3200 C2| Maxtor D740X 60gig | Pioneer 106S 16X Slot Load | Lite On 24x10x40x | Turtle Beach Santa Cruz | Blackice Rad | DD Maze2 | Lian Li PC-65 w/side window
Chuki is offline   Reply With Quote