So I guess my biggest question mark is the rad, since everyone seems to praise the ehiem pumps, and just about any block wil serve my purpose.
I was looking around today and saw "the cooling cube" at
Dden. It seems as thought it would fit in my case, and is big enough for a set of 120mm fans. Any comments on this rad?
This is my parts list so far, tell me good or bad, I'm a noob with water:
Ehiem 1250 With 1/2 to 3/8 adapter
Maze2 block (good enough right?)
Block for Geforce3 (recommendations anyone?)
"cooling cube" from Dden (3/8 in and out)
2x Sunon 120mm 90CFM Fan (think I'll run em off a 12v line with a pot,or use the 5 and 12 with a dpdt switch so I can tame em down a bit when idle)
10 feet clear silicon hose w/10 clamps
Resevoir (type and size?)
OK, That should get me up and runnin. I have 4 (2 in, 2 out) 80 MM case fans at the moment, but I'll probably have to lose the 2 intake to make room for the rad under the HDDs.