[Fixittt]

I was thinking about doing a really rought design in it based on Jaydees first block, center outlet one turn across the borrom and out. Instead of milling the channel, I want to take a 1/4 in end mill in plunge it like a drill bit, but stagger the plunges, so you are left with alot of small sharp edges. I also want to do this with a ball nose endmil, (has a ball on the end almost like a drill bit, so that the bottom of the channel will be un even. I thought of doing this will a drill bit, but the problem with that is drill bits flex way to much, and if I drilled to close to an existing hole, the drill bit will walk over to it and break. So I will have to use an endmill, as they dont flex.