Pro/Forums - View Single Post

schoolie · 02-23-2002, 08:30 PM

Thanks for the tip on the MAX chips. I didn't see in the specs that the accuracy is only 2C.

I think my water temp reading were off in my last evaluation. At the moment, Water 16.3C, CPU 26.3C (Compunurse), KR7A CPU 32C, Air 14.7C.

XP2000 1921MHZ
FSB 174 MHZ
Mult x11 ( think the bus freqs are higher than nominal to boost benchies

VCore 2.08V

I have an idea for a MAZE2 turbulator. Basically a copper wire in the form of a helix, about 11cm long and 1cm wide. It's going from the 1/2" tubing to the base of the MAZE2 inlet and should get some nice mixing going on

02-23-2002, 08:30 PM	#19
schoolie Cooling Savant Join Date: Feb 2002 Posts: 120	EMC2 Thanks for the tip on the MAX chips. I didn't see in the specs that the accuracy is only 2C. I think my water temp reading were off in my last evaluation. At the moment, Water 16.3C, CPU 26.3C (Compunurse), KR7A CPU 32C, Air 14.7C. XP2000 1921MHZ FSB 174 MHZ Mult x11 ( think the bus freqs are higher than nominal to boost benchies VCore 2.08V I have an idea for a MAZE2 turbulator. Basically a copper wire in the form of a helix, about 11cm long and 1cm wide. It's going from the 1/2" tubing to the base of the MAZE2 inlet and should get some nice mixing going on