i may do that, plenty of room for testing that, but as of right now my hard drive block seems to put the most heat into the water.
and before anyone gets mad about the fact that i am blowing the warm air from the rads into my case... the air comming off this same setup but with only one rad is 2-5 degrees over ambient. i figure it will go through fast enough that there wont be much saturation.... but if its too hot i can always make 90degree shrouds and blow the air out the side, then put a fan on the back (between the rads and above the pump)
but still i want everyones info... and mainly on material that i should make this out of
|