Quote:
Originally posted by Fixittt
Now Ihave heard of a "solder Sheet" its like a gasket that you can buy, and U can cut it to size. Then just heat in the oven or something like that and it flows to
where the flux was applyed. But then again, I have never seen it, nor have I ever soldered copper.
|
If you used sheet solder you would have to mill it out to the channel design so all the extra wouldn't drop into to channels and clog them up.
Soldering copper is very easy actually. Especially pipe. I just havn't figured out the best method for blocks and probably never will being I don't want a soldered on top. I want them removable myself.
I solderede to pennies together rather easily. It is just a matter of heating the material up to the same temp and letting the material melt the soloder not the tourch.