Pro/Forums - View Single Post - Anyone seen a similar design as this block?

jaydee · 03-15-2002, 10:09 PM

Ain't it purdy!!

Not to bad for doing it manually without the CNC. Milling is done. the channels are 5/16" wide and 5/16" deep. Tomorrow I will figure out what i will do for the top and then it should be done.

03-15-2002, 10:09 PM	#23
jaydee Put up or Shut Up Join Date: Dec 2001 Location: Spokane WA Posts: 6,506	Ain't it purdy!! Not to bad for doing it manually without the CNC. Milling is done. the channels are 5/16" wide and 5/16" deep. Tomorrow I will figure out what i will do for the top and then it should be done.