Pro/Forums - View Single Post

DoTheDog · 03-19-2002, 11:18 PM

I have recently found that I may have access to a CNC Mill. All I needed was a WB design to try out. After thinking about it, I came up with this.

Pardon the lame skillz:shrug: But I think you get the idea. There are eight 1/4" deep 1/4" wide channels flowing from the center. The outer channel gets wider as more water enters it. The outlet is 1/2". Do you think this would be worth calling in a favor to get milled?

Any and all comments/flames appreciated.

03-19-2002, 11:18 PM	#1
DoTheDog Cooling Neophyte Join Date: Aug 2001 Location: SLC, UT Posts: 39	Another WB Idea! Comments? I have recently found that I may have access to a CNC Mill. All I needed was a WB design to try out. After thinking about it, I came up with this. Pardon the lame skillz:shrug: But I think you get the idea. There are eight 1/4" deep 1/4" wide channels flowing from the center. The outer channel gets wider as more water enters it. The outlet is 1/2". Do you think this would be worth calling in a favor to get milled? Any and all comments/flames appreciated. __________________ a64 3200+ @ 240x10 Chaintech znf3-150 512MB Mushkin LII PC3500 @ 200Mhz 2-3-2-6 2x80GB SATA Seagate 7,200RPM RAID1 Sony 48x24x48 CDRW GFFX5700 Ultra H20 COOOOOLING Mag5, BIX, Maze4, 1/2" Tygon