Pro/Forums - View Single Post

DoTheDog · 03-19-2002, 11:45 PM

Thanks for the response redleader. I was thinking that if the water was moving in one direction around the outside that it would pull water through all the channels.

What kind of flow restriction were you thinking about? The way it is now, it should have very little flow restriction in that the 1/4" x 1/4" channels are about the same volume as a 1/2" ID tube, so there is 8x (8 channels) the volume coming out of the center as there is coming in and there are no 90 degree turns. Could you explain? I am a newbie at designing these things. Any help appreciated.

03-19-2002, 11:45 PM	#3
DoTheDog Cooling Neophyte Join Date: Aug 2001 Location: SLC, UT Posts: 39	Thanks for the response redleader. I was thinking that if the water was moving in one direction around the outside that it would pull water through all the channels. What kind of flow restriction were you thinking about? The way it is now, it should have very little flow restriction in that the 1/4" x 1/4" channels are about the same volume as a 1/2" ID tube, so there is 8x (8 channels) the volume coming out of the center as there is coming in and there are no 90 degree turns. Could you explain? I am a newbie at designing these things. Any help appreciated. __________________ a64 3200+ @ 240x10 Chaintech znf3-150 512MB Mushkin LII PC3500 @ 200Mhz 2-3-2-6 2x80GB SATA Seagate 7,200RPM RAID1 Sony 48x24x48 CDRW GFFX5700 Ultra H20 COOOOOLING Mag5, BIX, Maze4, 1/2" Tygon