Pro/Forums - View Single Post

jaydee · 03-22-2002, 07:36 PM

The new Maze 3 brought this design back to mind that I had laying around. The design itself was thought up by webmedic and I told him i would try to make one. I got the drawing made but when I went to run it through the CAM software the code was all messed up. I ran out of time to work on it so I gave up.

But anyway what do you think. The channel is huge. It would have a high volume of water going through it. It was made for 1/2" ID barbs.

03-22-2002, 07:36 PM	#1
jaydee Put up or Shut Up Join Date: Dec 2001 Location: Spokane WA Posts: 6,506	What do you think of this design? The new Maze 3 brought this design back to mind that I had laying around. The design itself was thought up by webmedic and I told him i would try to make one. I got the drawing made but when I went to run it through the CAM software the code was all messed up. I ran out of time to work on it so I gave up. But anyway what do you think. The channel is huge. It would have a high volume of water going through it. It was made for 1/2" ID barbs.