Pro/Forums - View Single Post

YardPig · 06-01-2001, 06:51 PM

I appreciate your opinion Joe. I ended up going with 1/2"ID, 5/8"OD reinforced hose. It seems to bend a little tighter than the non-reinforced.
Do you think this is overkill? I though besides the increased volume of water inside the lines, it would be easier on the pump and lower the pressure. I thought this would work for me.
The nice thing about this copper heater core I got is the inlet side has an adjustable valve on it to increase/decrease the amount of fluid flow. It's a real trick part out of an early suzuki jeep. If anyone wants to see a pick, I'll post one.

Thanks again, all the help here is appreciated.

Take care

06-01-2001, 06:51 PM	#15
YardPig Cooling Neophyte Join Date: May 2001 Location: Earth Posts: 21	I appreciate your opinion Joe. I ended up going with 1/2"ID, 5/8"OD reinforced hose. It seems to bend a little tighter than the non-reinforced. Do you think this is overkill? I though besides the increased volume of water inside the lines, it would be easier on the pump and lower the pressure. I thought this would work for me. The nice thing about this copper heater core I got is the inlet side has an adjustable valve on it to increase/decrease the amount of fluid flow. It's a real trick part out of an early suzuki jeep. If anyone wants to see a pick, I'll post one. Thanks again, all the help here is appreciated. Take care