Pro/Forums - View Single Post

Crappy · 03-27-2002, 07:27 PM

It should be the same height as the PC-70. The PC-70 picks up the height with the 5 1/4 bays on the top. Now if there is alittle more room there you can stand the BIX up on end with the fitting on top.

The way I have it now is a good fit and works fine with the fitting on the side. Just have to make sure you get all the air out of it

I did put a shroud on the 80mm fans going to the BIX those temp I gave are with the shroud. Temps were about 1 to 2c higher without it.

03-27-2002, 07:27 PM	#32
Crappy Cooling Neophyte Join Date: Nov 2001 Posts: 12	It should be the same height as the PC-70. The PC-70 picks up the height with the 5 1/4 bays on the top. Now if there is alittle more room there you can stand the BIX up on end with the fitting on top. The way I have it now is a good fit and works fine with the fitting on the side. Just have to make sure you get all the air out of it I did put a shroud on the 80mm fans going to the BIX those temp I gave are with the shroud. Temps were about 1 to 2c higher without it. __________________ AMD XP 1900+@1680 1.75V CPU Temps 28c Idle 38c Load Case Temps 24c to 26c DD MAZE2 Block 1/2" Black Ice Xtreme Panaflo 120mm 86 cfm Eheim 1048 Pump with 1/2" hose Abit KR7A Motherboard (Non-Raid) 256mb Kingmax PC-2700 IBM 20gig ATA66 Hard Drive Plextor 24/10/40 CD-RW & Sony 16x DVD-Rom Gainward GeForce 3 Ti200 64MB (250/575) 3.8ns mem Sound Blaster Audigy Linksys 10/100 network card