Pro/Forums - View Single Post

Memphis · 07-22-2001, 10:53 PM

I forget who told me about milling a block in a drill press before. They were a member of these forums and had apparently made their own block using a milling bit in a small drill-press.

I'm a bit worried concerning the safety of doing it this way, but I figure if I go very slowly it should be OK. And I will be using cutting oil.

If anyone thinks this is not wise, please let me know.

07-22-2001, 10:53 PM	#4
Memphis Cooling Neophyte Join Date: Dec 2000 Location: Melbourne, Victoria, Australia Posts: 45	I forget who told me about milling a block in a drill press before. They were a member of these forums and had apparently made their own block using a milling bit in a small drill-press. I'm a bit worried concerning the safety of doing it this way, but I figure if I go very slowly it should be OK. And I will be using cutting oil. If anyone thinks this is not wise, please let me know. __________________ My first computer:http://www.overclockers.com.au/pcdb/...phis&page=pics My second computer: 1.2 GHz AXIA, MSI K7T Turbo LE, 256 MB Kingmax PC150 RAM Gigabyte 32 MB GeForce IIMX, 10/100 NIC, Quantum 40GB 7200rpm ATA100 HDD KDS 19", Creative 12x DVD, CD Writer, Dual boot Win98 SE/Linux Red Hat 7.1 Email me: atrewin@hotmail.com