Pro/Forums - View Single Post - Need help w/ watercooling an Inwin Q500 tower

ECUPirate · 03-30-2002, 12:07 AM

I'm not quite sure that we're on the same page... If I turn the PSU sideways and sort of lined up the PSU w/ the 80mm exhaust, it seems like it would block my view of the WB in action (big deal), but would definitely hinder the operation of the slide out motherboard tray. Oh, and the only way I could get it to fit would be to cut away the support bar that runs across the case. (the Q500 is narrower than I'd like) I'm really starting to not like this case... pity, I have two of them.

03-30-2002, 12:07 AM	#3
ECUPirate Hottest Stank of them All Join Date: Mar 2002 Location: Washington, DC area Posts: 533	I'm not quite sure that we're on the same page... If I turn the PSU sideways and sort of lined up the PSU w/ the 80mm exhaust, it seems like it would block my view of the WB in action (big deal), but would definitely hinder the operation of the slide out motherboard tray. Oh, and the only way I could get it to fit would be to cut away the support bar that runs across the case. (the Q500 is narrower than I'd like) I'm really starting to not like this case... pity, I have two of them. __________________ Does a radioactive cat have 18 half lifes? --Kenny my pimpin' rig: ...previously poorly cooled... 486DX-2 66mhz @ 75mhz, 4Mb ram, shared, 256Mb hard drive Onboard VGA, watercooled, of course 16-color monitor, labtec speakers, 28kbs USRobotics modem Windows XP (think about it) Maze 3, DDen GF3 block, Eheim 1250, econoline van HC, 1/2" hose w/ 5/8" fittings Comair 172mm fan