Pro/Forums - View Single Post

Jim · 03-30-2002, 05:02 PM

Hey DV-
Looks good. First, what type of clamps are you using? Second, what fitting did you use to make that 90 degree turn out of the suction end of the pump? I could use that in my setup.

I suppose the "T" could be moved just out from the high connector on your block to aid in air extraction.

I have forgotten, been a while, is that a chevette or fiero heater core?

Good work.
Jim

03-30-2002, 05:02 PM	#31
Jim Cooling Savant Join Date: Feb 2002 Location: Illinois Posts: 389	Hey DV- Looks good. First, what type of clamps are you using? Second, what fitting did you use to make that 90 degree turn out of the suction end of the pump? I could use that in my setup. I suppose the "T" could be moved just out from the high connector on your block to aid in air extraction. I have forgotten, been a while, is that a chevette or fiero heater core? Good work. Jim