Pro/Forums - View Single Post

jaydee · 03-31-2002, 11:14 PM

The only thing I do not quite understand about the Maze 3 is the inlet position and the post there. I assume they wanted that post to be over the core of the cpu and raise the heat up it while the water on both sides cool it. But those channels are almost the same size as the inlet barb? Isn't that kinda inefficent. I would think that you would devide the barb ID size by half and make chanel width around that post that number so the flow on both side is more equel. Of course I am usually wrong about that stuff.

Non the less I e-mailed them my commments which where all good and they did reply. They are good with me. That milling job is just cool. I really hope it works good!!!

03-31-2002, 11:14 PM	#78
jaydee Put up or Shut Up Join Date: Dec 2001 Location: Spokane WA Posts: 6,506	The only thing I do not quite understand about the Maze 3 is the inlet position and the post there. I assume they wanted that post to be over the core of the cpu and raise the heat up it while the water on both sides cool it. But those channels are almost the same size as the inlet barb? Isn't that kinda inefficent. I would think that you would devide the barb ID size by half and make chanel width around that post that number so the flow on both side is more equel. Of course I am usually wrong about that stuff. Non the less I e-mailed them my commments which where all good and they did reply. They are good with me. That milling job is just cool. I really hope it works good!!!