Pro/Forums - View Single Post - Thinking of building my first W\C setup !

Brad · 04-03-2002, 01:24 AM

the maze3 won't be able to have 2 pelts. the maze3 can have one only

the maze2-1 and 2-2 are the same block, they just use differant mounting techniques

if you buy the socket 478 adapter they will fit fine on any socket 478 board

I'd go with 1/2 fittings myself

the danger den heater core is straight out of a car, you can buy it from autozone, but after you put 1/2" fittings on the autozone one, it comes out about the same price.

a 172w or 220w pelt will be fine, but 2x 120w would be fine too. more than that is probably getting a bit excessive

04-03-2002, 01:24 AM	#6
Brad Thermophile Join Date: Oct 2001 Location: Nuu Zeeelin Posts: 3,175	the maze3 won't be able to have 2 pelts. the maze3 can have one only the maze2-1 and 2-2 are the same block, they just use differant mounting techniques if you buy the socket 478 adapter they will fit fine on any socket 478 board I'd go with 1/2 fittings myself the danger den heater core is straight out of a car, you can buy it from autozone, but after you put 1/2" fittings on the autozone one, it comes out about the same price. a 172w or 220w pelt will be fine, but 2x 120w would be fine too. more than that is probably getting a bit excessive __________________ 2x P3 1100's at 1400, Abit VP6, 2x Corsair 256mb PC150 sticks, 20gb 'cuda ATA-III, 2x 40gb 'cuda ATA-IV in raid 0. 20" Trinitron. No fans 2x 2400+ at 2288mhz (16.0 x 143), Iwill MPX2, 2x Kingmax PC-3200 256mb sticks, 4x 20gb 60gxp in Raid 5 on a Promise SX6000. Asus Ti4200 320/630. Cooled by Water