well shaddy i got most of the stuff @ home depot (barbs, silicon, acrylic tops which are made outta a sheet of acrylic) and i got the tube from petsmart, its just a gravel cleaner that i cut the ends off of and glued some tops on.....also ill just fill it like u would normaly fill an inline system..i just wont have to bleed it
ph i drilled it with a a drill w/ a 1/2 drill bit the i had to take a dremel and make the hole a lil bit wider (barbs wouldnt go in)..the only problem i had jus using the drill is i couldnt stop it in time before it hit the other side after i got threw the first hole....next time im gona use ea drill press....
btw usplastics is where i plan on gettin all the stuff for my next adventure with this...i dont recommend using this silicon stuff...havent had a chance to test it with a pump, just been filllin it in the sink and cing what happens and it wuz leakin (thats y theres so much silicon on some spots and not so much on others) so i should begettin my pump soon..lol im praying it just doesnt blow apart on me...i plan on using some arcylic weld #3 on the next project...
http://forums.bit-tech.net/showthrea...&threadid=6791 theres where i asked linear about it