That's what I like about you guys always making me laugh. LMAO
Well, ready for a LOOOOOOOOOng story?
Firstly I mounted the heater core on the rear of the case with the inlets at the bottom. Took some snaps as things progressed.
Later on I changed it and mounted it with the inlets at the top, since the tubing (copper) didn't work out with the inlets down at the base of the case. And I took snaps of that too.
Then I read the post here about someone wanting a core with BOTH inlets at 5/8" or something along those lines. So I dug through my folder with the cooling snaps and put the nice clean one up on the posting site with the inlets at the bottom: on Andale.
Posted the snap here with the inlets postioned at the bottom, as they were when I first mounted the core, BUT the gremlins wouldn't allow the entire snap to post up here on ProForum! The bottom of the image kept getting cut off, so you couldn't see the "barbs". ARRRRRRRRRRRRRR
So I went back edited the g.d. snap by inverting it 180 degress so the inlets (which is what was the point of interest here) were positioned on the TOP and I posted it again on Andale, and then put it up on the Forum. The base of the image is still chopped off.
Boy what a PITA huh?
Jim