I have a question, with regards to the heat expansion and contraction differences between the clear top, the fittings and the block itself. I am at the moment busy re-building a
Chip-Chiller for a customer, and he said he had a poly-block, that he wanted to use, he might want to go the Maze-3 way, and asked me if I would recommend such a move...
the Chip-chiller can sustain 0c liquid on full load and might even go down to -10 , depending on ambient and load conditions....
this means that the block will see at most a 35degree delta from where is was assembled, (+25c) to where it is in opperation....
how brittle will the top be at cuch a temp..... I have made one
see-through block, for show-case perposes only, and I refuse to use it in conditions like I just discribed
Can I recommend the Maze, or any see-through for that matter, to be used in conjunction with what I'm building?