Quote:
Originally posted by Hellion_Prime
I used some hydraulic quick connects for a project of mine recently, mine were 1/2" NPT fittings, made from brass. I ordered them from the Surplus Center, cost listed in the catalog for 1/2" was $12.95 for the male/female set. I'll list the relevant information below:
Surplus Center year 2000 catalog
contact# 800-488-3407
Item# 928, 1/2" NPT female 2 peice coupler $12.95
Item# 928-C 3/4" NPT female, 2 peice coupler $19.95
Item # 928-AA 1/2" male tip only $3.95
Item # 928-D 3/4" male tip only $6.95
I'm not sure if they're in the newer catalog or not, as I haven't got it handy. Couldn't hurt to call and ask, however. Hope the information helps.
--HP
|
So basically with my dangerden block with the 1/2" setup the ID of the 1/2" barbs is near 1/4" right? So if I got the 1/2" NPT female and 1/2" male tip as listed above it should work fine right? I'm assuming that the 1/2" NPT male tip for the coupler has a ID similar to the 1/2" barbs I have on my waterblock?