Well I went to HomeDepot since it's 5min away and I got the fittings I need to convert my 1046 to 1/2output and I figured that I can put the hose all the way to the thread of the inlet and double clamp it. I hope that with no right angles and 1/2 fittings everywhere after the outlet it will be enough flow. If not I'll use this for my P3 600 server, and get the 1048.
Man coverting from 1/8 to 1/2 was almost impossible I can't belive I was able to do it with ONLY three fittings. HAH HA
It looks pretty cool too with out my ghetto JB weld job I did last time. I was going to get brass a barb for the inlet but I wanted to do it with one fitting and I couldn't find what I needed which was 3/8pipe thread to 1/2 OD barb.
I'll post some picture once I progress more with my project which I belive will be the smallest self contained WC system around
until Una finishes his nanocube. He will have me beat by about an inch or so in each demention
Thats all the clues I'm giving.
Thats why I'm trying to make do with a 1046 or 1048 and keep the pump small.