Holy Shit Stylerod-
I wish I would have seen this image of your block sooner, no fault of yours. Thanks regardless of the timing. I think I may have asked Danger Den for a refund if I would have seen this issue.
I am again concerned.
Jessfm that posted in this thread much early on stated that his company had problems with the plastic cracking around the barbs the thickness in his case was 11 mm I believe.
Hummmm .... the plastic on these blocks is 8 mm.
Too bad this doesn't come with an optional copper top, SOLDERED in place, or better yet maybe it would be better for the optional top to be this clear plastic.
I got my replacement block today from Danger Den, I don't see any cracks so far.
I wonder how the cracking scenario goes with these clear top blocks? Do the cracks appear early or is there a routine for a daily/weekly check on this?
Does this material have built up stress?
My stress is building.
Image of replacement block.
Jim
