Quote:
Originally posted by Brad
sorry to hear that jim, maybe you should try remounting the block
|
Brad I think I agree.
last night I shut off the computer and let the pump only run, to get more air out and check for leaks.
This morning I powered up, and the case temp read 20c (using MBM) but IMMEDIATELY the CPU was at 33C! That ain't right. The CPU at start up should have read around 28-29 and then inched up as the case temps rose. I think I may not have enough AS3, I went very very thin this time.
My mount is tight, can't swivel the HS at all. SO after work today I think I'll pull it check the print on the block and remount. Clean the core off and apply the AS3 fresh and clean the block smear on some AS3 and wipe.
What do you guys think?
Jim