Pro/Forums - View Single Post

terabyte · 10-20-2001, 06:43 PM

I got my heatercore this week from AutoZone for $24 and change. Well here is my progess. I still want clean the extra JB Weld off the pipes and paint all the edges but that will have to wait till the JB Weld has cured.

Hacked off first pipe and cleaned it up a bit. Extra piece on top for comparison.

Liberal appilcation of JB Weld around the part of the hose bard that is going in the pipe.

5 Minutes in the oven to harden a bit of the JB Weld in the second pipe. I needed to do it into two parts because I needed a bunch of JB Weld. This idea I stole right off Procooling.com

Both fitings done!

How do you think this setup with Dual Panaflo H1A's will cool a couple of pelts? HAH HAH AH

[ 10-20-2001: Message edited by: terabyte ]

10-20-2001, 06:43 PM	#1
terabyte Cooling Neophyte Join Date: Mar 2001 Posts: 44	Finished Heatercore mod. I got my heatercore this week from AutoZone for $24 and change. Well here is my progess. I still want clean the extra JB Weld off the pipes and paint all the edges but that will have to wait till the JB Weld has cured. Hacked off first pipe and cleaned it up a bit. Extra piece on top for comparison. Liberal appilcation of JB Weld around the part of the hose bard that is going in the pipe. 5 Minutes in the oven to harden a bit of the JB Weld in the second pipe. I needed to do it into two parts because I needed a bunch of JB Weld. This idea I stole right off Procooling.com Both fitings done! How do you think this setup with Dual Panaflo H1A's will cool a couple of pelts? HAH HAH AH [ 10-20-2001: Message edited by: terabyte ]