It's one 1/2" center inlet and two 3/8" side outlets. The cone shape in the block itself will have more ridges than the model. They will be closer together ( about three per mm ) and more shallow. The distance between the cone shapes will need to be experimented with by making multiple tops. The distance in the model shown is approximately 1/4".
jaydee116, I don't think two 1/4" barbs will equal the same as one 1/2" so your flow may be a little restricted. When you dig it out wider are you going to switch to two 3/8" outlets? Also I'm planning on having my two outlets go directly to a res so they don't have to merge with adapters, is that how you did yours?
|