Pro/Forums - View Single Post

superart · 05-07-2002, 10:09 AM

I am trying to design my first block. I am useing a proLIGHT machineing center from Light Machine Corp. I made the drawing in masterCAM, and generated the NC code. I then opened the code with WPLM1000 ver. 1.05, the controlling software provided with with the mill. When i verify in WPLM1000 program, nothing happens, but when i verify in mastercam, it turns out fine. Is it possible that the NC code generated by matercam is not compatable with WPLM1000?

If i run the program, the mill goes to the factory set Home Position.

I would really apreceate any help you guys can give.

Thanx

05-07-2002, 10:09 AM	#1
superart Cooling Savant Join Date: Mar 2002 Location: FL Posts: 787	haveing problem milling. I am trying to design my first block. I am useing a proLIGHT machineing center from Light Machine Corp. I made the drawing in masterCAM, and generated the NC code. I then opened the code with WPLM1000 ver. 1.05, the controlling software provided with with the mill. When i verify in WPLM1000 program, nothing happens, but when i verify in mastercam, it turns out fine. Is it possible that the NC code generated by matercam is not compatable with WPLM1000? If i run the program, the mill goes to the factory set Home Position. I would really apreceate any help you guys can give. Thanx __________________ When you do things right, people won't be sure youv'e done anything at all. Looking to buy/trade for used Deep Fryer and Vacume Pack Sealer.