Hey Bill.
I keep getting asked for figures and I find it very anoying. IMHP its sometime better to say nothing, then to half tell the truth.
In some ways I could do a half cocked test ( i can supply a constant heat source of 2kw, I can measure(accurate to 1%) the Air & water temps in/out/Air , I could even measure the pressure differencial between inlet&outlet. What I can't measure and for me its very important, as shown by your graphs on the rad test Article , is the flow rates (Air /water).
I could guesstimate I suppose
End of the day its hard to find someone 1: willing 2:capeable 3:None Bias to test/review most any products.
*note for Bill*
I have got the SocketA version of the neptunes done, would you still like to test/review one as we discussed at tekforums a while back?????.
End of the day it still boils down to price ballance. We couyld spend $1000's getting products reviewed until one comes out that looks about right.
I will do what i can, within the limitations of my knolledge/equipment. I would love to have a Lab at my disposal to do a fully controlled test - sadly Im not rich
