I'm also sorry if my post was seen as advertising. pH and BillA, thanks for the input on testing technique. I can't measure pressure, but my rig allows me to deliver a constant and known head of water to the units on test, and I can measure flows with a workable accuracy.
I've been winding Jess up recently about 1/2" stuff, which when I stick the verniers down them I find the ID is much less than 1/2". I have spent some time researching fittings and some care in measuring to ensure my 1/2" is actually a minimum of 1/2" ID all the way to the w/b, rad, etc.
The rig certainly isn't built to any lab spec, and results from it can not accurately be compared to another rig because so many other conditions alter. But I hope to do some shootouts, and get some comparison results that are of use to the overclocking community.
__________________
Rich M
|