Pro/Forums - View Single Post - Sigh. . .Think I Know My Problem. . .BUT. ..

Alaric_2000 · 05-19-2002, 09:32 AM

XP 2100+
1.78V
Inside Of Case << Fan << Rad << Fan << Outside of Case
Bottom Front
Antec SX1240
Nice thin layer of AS3 (enough to coat the core, but not more)

I would say that if the water is foamy, there's too much air, huh? It's VERY cloudy. Should I open the top of my res to let the air out? Let it cycle with the top off?

I'm using Tygon R-3603 ID 3/8" with a 1/8" wall.

05-19-2002, 09:32 AM	#18
Alaric_2000 Cooling Neophyte Join Date: May 2002 Location: Yardley, PA Posts: 47	XP 2100+ 1.78V Inside Of Case << Fan << Rad << Fan << Outside of Case Bottom Front Antec SX1240 Nice thin layer of AS3 (enough to coat the core, but not more) I would say that if the water is foamy, there's too much air, huh? It's VERY cloudy. Should I open the top of my res to let the air out? Let it cycle with the top off? I'm using Tygon R-3603 ID 3/8" with a 1/8" wall.