Pro/Forums - View Single Post

XiveX · 05-19-2002, 10:04 PM

Well the thing is, if it was an air leak at the suction end of the Eheim 1250 pump, it is NOT coming from the elbow. Its coming from where the elbow connects to the pump housing at. I know this because I can NOT get the Tygon (1/2" ID Thickwall) off the elbow for the life of me. I mean I'm scared of breaking or damaging the pump I've pulled so hard on it. I'll probably have to cut it off if I try that. BTW--That is the only thing that does NOT have a clamp (screw-type) on it...LOL! Only because its so tight naturally....no need for one.. I can't even pull the damn thing off.

I'll try the other one tomorrow probably. Any other ideas guys??

Thanks,

XiveX

05-19-2002, 10:04 PM	#6
XiveX Cooling Neophyte Join Date: May 2002 Location: Cleveland, OH Posts: 15	Well the thing is, if it was an air leak at the suction end of the Eheim 1250 pump, it is NOT coming from the elbow. Its coming from where the elbow connects to the pump housing at. I know this because I can NOT get the Tygon (1/2" ID Thickwall) off the elbow for the life of me. I mean I'm scared of breaking or damaging the pump I've pulled so hard on it. I'll probably have to cut it off if I try that. BTW--That is the only thing that does NOT have a clamp (screw-type) on it...LOL! Only because its so tight naturally....no need for one.. I can't even pull the damn thing off. I'll try the other one tomorrow probably. Any other ideas guys?? Thanks, XiveX