Pro/Forums - View Single Post

socketman · 05-21-2002, 11:16 AM

i will actually have two pelts, spaced a few inches apart in a 15in x 6in x 6in tunnel...
the tunnel will have two "levels". both the top and bottom will have 2 case fans pushing air thru them. Between each floor will be some serious insulation ensuring the hot and cold dont mix. If i need a heat sink on the hot side, thats no problem.
Between each case fan will be a desiccant wheel to remove humidity from the ambient air.
The air will then be piped to the case, where hopefully the humidity will be low enough to prevent condensation.
I appreciate your input guys. so basically i need a heatsink and a means to remove the heat to prevent a burnout. Sounds good.
I NEED to get the hot side temp to around 120 F.. any idea which wattage of pelt will do that?

thanks guys, I appreciate your input.

05-21-2002, 11:16 AM	#4
socketman Cooling Neophyte Join Date: May 2002 Location: Dixieland Posts: 4	i will actually have two pelts, spaced a few inches apart in a 15in x 6in x 6in tunnel... the tunnel will have two "levels". both the top and bottom will have 2 case fans pushing air thru them. Between each floor will be some serious insulation ensuring the hot and cold dont mix. If i need a heat sink on the hot side, thats no problem. Between each case fan will be a desiccant wheel to remove humidity from the ambient air. The air will then be piped to the case, where hopefully the humidity will be low enough to prevent condensation. I appreciate your input guys. so basically i need a heatsink and a means to remove the heat to prevent a burnout. Sounds good. I NEED to get the hot side temp to around 120 F.. any idea which wattage of pelt will do that? thanks guys, I appreciate your input.