Stumbling blocks on my end:
No laboratory chiller to control water inlet temperature. I can still get numbers but this will result in constantly changing boundary conditions. Possible to get around this?
Flow rate measurement. I have a relatively inexpensive flowmeter that is +/- 6%. This turns out to be the major stumbling block I think.
Still have to decide upon a way to assign watts. I'll most likely go with the Duron 1200MHz at 1.75V so that I can pull the typical max load number from the AMD spec and just go with that. Comments?
Good news: CPU die measurement possible with reasonably good accuracy and resolution, wb inlet and outlet temps are also I think ok (you tell me hehe).
|